Icom IC-460 Manuel d'utilisateur télécharger pdf (Page 16)

BIIS OPERATION

■ Transmitting a call

Total of a 3 ways for code selection are available—selecting the call

code from memory, entering the call code from the keypad and call-

ing back from the queue channel record.

Using call memory

q While in the standby condition, push [P1] (Digital) to enter the

call code memory channel selection mode.

w Push [ ]/[ ] to select the desired call code.

e Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the transceiver re-

peats the call 3 times (default) automatically, and

“”is

displayed during each call. However, an error beep sounds

and

“”is displayed when no answer back is received

after the calls.

r Push [PTT] to transmit; release to receive.

t Push [P3] (Moni(Audi)) to send the “Clear down” signal.

Call code text is displayed.

Calling back from the queue channel

q While in the standby condition, push [P1] (Digital) for 1 sec. to

enter queue memory channel selection mode.

w Push [ ]/[ ] to select the desired record.