Icom IC-R1500 Manuel d'utilisateur télécharger pdf (Page 49)

OTHER FUNCTIONS

Weather channel selection

q Push [MR•SKIP] twice and rotate [DIAL] to select weather

channel group, then push [MR•SKIP] again.

w Rotate [DIAL] to select the desired weather channel.

e To cancel the weather channel, repeat step q and select

the memory channel group, “bAnk --” or push

[V/MHz•SCAN] to select VFO mode

Weather alert function

NOAAbroadcast stations transmit weather alert tones before

important weather announcements. When the weather alert

function is turned ON, the selected weather channel is moni-

tored each 5 sec. for the announcement. When the alert sig-

nal is detected, the “AL.T” and the WX channel are displayed

alternately and sounds a beep tone until the receiver controls

are manipulated. The previously selected weather channel is

checked periodically during standby or while scanning.

q Select the desired weather channel.

w Turn the weather alert function ON in set mode

➥ Push

[SET•LOCK]

to enter set mode.

➥ Push

[SET•LOCK]

or [S.MW•MW] to select the weather

alert item, then rotate [DIAL] to set ON.

➥ Push any key below the display to exit set mode

e Select the desired stand-by condition.

• Selects VFO or memory channel.

• Scan or priority watch operation can also be selected.

r When the alert is detected, a beep sounds and the follow-

ing indication will be displayed.

t Turn the weather alert function OFF in set mode.

NOTE: While receiving a signal (on a frequency other than

the weather alert ON frequency), the receiving signal or

audio will be interrupted momentarily every 5 sec.

(approx.)

in case the alert function is turned ON. This is caused by

the WX alert function. To eliminate the interruptions, set the

weather alert item OFF in set mode

Shows above indications alternately.

[MR•SKIP]

■ Weather channel operation (USA/CANADAversions only)

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Pas de commentaire

Icom IC-R1500 Manuel d'utilisateur Page 49