Icom IC-M90 Manuel d'utilisateur télécharger pdf (Page 33)

OPTIONAL SPEAKER-MICROPHONE

■ HM-125 Descriptions

NEVER immerse the connector in water. If the connector be-

comes wet, be sure to dry BEFORE attaching it to the trans-

ceiver.

NOTE: The microphone is located at the top of the

speaker-microphone, as shown in the diagram above. To

maximize the readability of your transmitted signal (voice),

hold the microphone approx. 2.5 cm (1 inch) from your

mouth, and speak in a normal voice level.

■ Attachment

Insert the speaker-mic connector on to the [SP MIC] connec-

tor and carefully screw it tight, as shown in the diagram

below. Be careful not to cross thread the connection.

IMPORTANT: KEEP the transceiver’s [SP MIC] connector

cap attached when the speaker-microphone is not in use.

Water will not get into the transceiver even if the cover is

not attached, however, the terminals (pins) will become

rusty, or the transceiver will function abnormally if the con-

nector has become wet.

Alligator type clip

To attach the speaker-mic.

to your shirt or collar, etc.

PTT switch

Transmits during push.

Receives during release.

Microphone

Speaker

Set the triangle

mark to the front

side.

CAUTION: Attach the speaker-microphone’s

connector securely to prevent accidental

dropping, or water intrusion in the connector.

Detaching:

Pull up the cap

in the direction

of the arrow to

detach it.

Attaching:

Attach the cap

in the direction

of the arrow

completely.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Commentaires sur ces manuels

Pas de commentaire

Icom IC-M90 Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour bateaux Icom IC-M90